MickeySw
Featured content
0
Reaction score
588

Latest activity Postings Post Areas About

    • MickeySw
      The most likely scenario is that the DC/DC is (currently) not working, I.e. all low voltage load has to be supported by the 12V aux...
    • MickeySw
      Imho your problem is an (intermittent) fault of the car’s DC/DC circuit or it’s voltage reporting. If it ‘behaves’ the day it’s booked...
    • MickeySw
      You can reset the trip data to get an idea of battery health, obviously the generic consumption used will soon be updated with real...
    • MickeySw
      As mentioned before, when READY, that voltage should be around 14V (provided by DC/DC)? Might be worth borrowing a multimeter and...
    • MickeySw
      It used to be a lot more common after failed DC charging sessions. FW upgrades over the years seem to have helped but many drivers got...
    • MickeySw
      MickeySw reacted to Ian Key's post in the thread MGS5 12 Volt Battery Issues with Agree Agree.
      Sometimes it is advantageous not to use a memory keeper/minder and force the car to reboot. It gives the various modules a chance to...
    • MickeySw
      It’s generally recommended to fully charge even a new 12V battery before you install it (it may have been on the shelf for some time)...
    • MickeySw
      MickeySw replied to the thread MGS5 12 Volt Battery Issues.
      There will be a lot of errors once you restart the car, usually turning the steering wheel to both extremes will clear most faults, if...
    • MickeySw
      MickeySw replied to the thread MGS5 12 Volt Battery Issues.
      There is a good chance that the four year old 12V aux is causing the problem, make sure you fully charge the new battery before you...
    • MickeySw
      MickeySw replied to the thread Is this SoH OK?.
      I’m pretty certain that (near) perfect top balancing is possible with degraded cells; SoH of my 15 year old EV is around 80%, yet top...
    • MickeySw
      MickeySw replied to the thread Is this SoH OK?.
      Balancing (at least the way I understand it) commences when charging is completed (I.e. when the first cell reaches the cut-off...
    • MickeySw
      MickeySw reacted to W12Lad's post in the thread Is this SoH OK? with Funny Funny.
      In the last 18 months after going EV, I've devoured the internet on all things electric and read through all these great posts daily...
    • MickeySw
      MickeySw replied to the thread Is this SoH OK?.
      Afaik the flat LFP charge/discharge curves are challenging for the BMS when it comes to accurate measure SoC, however I wouldn’t have...
    • MickeySw
      MickeySw replied to the thread Is this SoH OK?.
      You mean current reduction? Is the ZS using active balancing, passive methods usually doesn’t require extra energy? Out of curiosity...
    • MickeySw
      MickeySw replied to the thread Is this SoH OK?.
      Charging to 100% isn’t the issue, I’m more concerned about the resulting 136mV difference after @doubledroz ’s failed calibration? I...
  • Loading…
  • Loading…
  • Loading…
Back
Top Bottom