Recent content by Blacksmith

I have the same space saver from a VW golf and a dry fit only works on the rear of the 77. The Front caliper is way too big for it. Looks like a hunt for a relacement. It will still work for now, I will just need to add a car stand until i can replace it. This one will soon to be available for...

I have the same space saver from a VW golf and a dry fit only works on the rear of the 77. The Front caliper is way too big for it. Looks like a hunt for a relacement. It will still work for now, I will just need to add a car stand until i can replace it.

12 month update: The fridge has run continuously since I installed the setup. No problems, It hasn't run out of power, and seems to be able to dissipate the heat well enough. I didn't bother with a solar panel, as it has performed well enough as is.

The charger was manufactured in March of 2021, so Tech has moved on a bit since then.

Still happening in Australia, when using the built in Nav. I use Google or ABRP now.

After having the MG chargehub replaced twice under warranty for faulty software, I returned it for a refund. There is another firmware update being written at the moment, but who knows when that will be be available. I will put up with a dumb portable charger until new bi-directional...

The jack points are marked by arrows on the black plastic body sides. The lift points are the seam (circled blue), or the "puck" point (circled green). If using the puck points, remove the plastic cap / plug, and insert a puck (like the Tesla ones) or a rubber block to cover the hole, and place...

The black does extend below the roof line, and when you open the boot lid, you can see it is vinyl wrap. The question is (as suggested by the sign writer), is it a full proper paint job underneath, or a half arsed job just good enough for the vinyl cover? My experience with vinyl wrap is...

Has anyone removed the black vinyl roof covering? I had another layer added on my silver 77, not sure how long it will last, so when I have to remove it is there continuous paint on the roof like the other models?

What other alerts would this also turn off?

It seems that the latest update to the entertainment software may have turned this "feature" off.

green, is for the "puck, rubber block with a spigot", blue one is for seam lift, but should use slotted rubber block to distribute the load onto the body as well as the seam, or a longer seam contact.

I have tried to apply the 1.0.8 ? latest firmware update, it failed a couple of times, and i may have modified another setting in the process, and now I can't connect or login to the charger. Is there a hardware reset available (like a modem) or do I have to try my luck with MG somehow?

This has been my project, and so far it has performed fantastically. It runs 24/7.