Recent content by callifo

I had heard it's only free for the first two years and then it's subscription.

I wonder if the updated integration now works... Being stuck on a year old version with no updates isn't great.

I suspect it might only be 1.6J. I looked through the chargers setup page, through the OCPP response messages, and through the debug logs and cannot locate anything that says what version it is. You could always try [email protected] which is listed on the MG Chargehub support page. I...

Yes it is due to low solar, but as mentioned its HA driving the charger amp setting. Just starting charging, and then setting the charger to 0A should suffice to test. Previously I would set it to 6A, start it, and then set it to 0A, and the charger would remain as 'On' and '0A', and its status...

OCPP integration from HACS, setup OCPP server then point the charger at it

After a couple of days, does look like a bit of a mess. Most prominent issue is you can't suspend the charger anymore. Turn on charger, set to 6A, charge for a bit, then set to 0A. Previously charger would stay running but show status as SuspendedEVSE. Now, charger turns off, charger status...

I didn't mean to imply the issues above are from this firmware specifically, they have been present in the first two firmwares, hoping they are fixed this time ? My charger gets a workout, when charging on solar, the charge rate is changed every 30 seconds to follow available solar.

I have, not huge difference but I'm using my mine with Home Assistant. They have stuffed up the version number though... In the webpage it's shown as 1.1.0.8. It's good it's been released though as I bugged MG quite for a while for a new release and they originally told me May 2024, so September...