I’ve had a Project EV charger for around a year. As far as I’m aware there isn’t an option in the settings menu to do that.
If you are concerned about drawing undue attention to your charger, it gets worse when charging as a large green circle flashes on the front black glass panel.
Perhaps...
I drove the silver car from Chorley MG this week too.
The auto parking brake had a slight issue in that unlike our Gen1 it released the brake on inclines but then rolled back unless quite a bit of pressure was applied to hold the car or pull forward.
The car drives well but in all honesty I...
We had the ZSEV in for its 1st Service yesterday & the Service sheet claims it had the KERS3 RC007 brake light update done too.
I’ve not heard on the Forum that the issue also affected the ZSEV ??
We had the ZSEV in for its 1st Service yesterday & the Service sheet claims it had the KERS3 brake light update done too.
I’ve not heard on the Forum that the issue also affected the ZSEV ??
Wife & I invested 210 mile round trip in Chorley MG Burnley today.
1st Service and a clunky steering wheel sorted together with all updates as required.
We even took a test drive in the New Model.
Can’t speak more highly of the care and friendly attention we received.
Many thanks to all...
Not sure but I can say that an email to their tech support was very well responded to when I had an issue with a delayed charging question.
[email protected]
I need to do some practical tests to determine if there's a useful spread of light from the door card area before deciding. I thought having light that potentially also shines on the kickplate would be useful for getting in & out too.
I'm just not a great fan of hacking away at the headlining...
Ours is a Remeha Avanta, but quite a few of the later boilers have opentherm interfaces as standard now.
This link may be useful Opentherm Boilers & Controls | Compatibility Guide
I have installed EvoHome by Honeywell. I have to say the comfort level is very noticeable, no more variation due to weather influences. We have an opentherm interface that controls the burner modulation, that’s the key money saver with the Honeywell system I think. Assuming you have an opentherm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.