Recent content by GRFL

I sorted it. Found a thread with the file.

Hi, can you send me that file please? I have the same issue. Thanks. I saw the file after posting. What I did: Extract the zip file to unpack the .BIN file. Transferred to a USB stick Put the stick into the phone/tablet USB port(left port) Open engineering mode on the car screen Hit version...

I hit the update dab setting, it asked for a file and the radio tab just says initialising module. Do you think a factory reset will sort. I'm not sure if resetting will revert to its Chinese settings.

Hi, Has anyone got an MG5 radio initialisation file? I may have cleared my settings 😅 Thanks.

None now. I had a chassis that came as a job lot of stuff. I'm not Into the TV stuff but the spring came in handy. It looked like a DIY monster truck.

The struts are original. I just added springs from an old RC car. Once you pop the strut off, you can unscrew the head and pop the spring in. I am sourcing a new set of springs as the set on the video doesn't work all the time. I'll update once I've tested.

Close. But a different type of spring lol. Just posted a vid of what I've done.

Sprung. Just posted a vid.

MISSION COMPLETE I went through a few different sized springs but got there in the end.

I have had a search but only find posts about the electric system.

Does any one know if there are any automatic boot struts(not electric) available. If so. Where can I find them? Thanks.

There's a radar sensor on the lower bumper that the adaptive cruise control uses.

Has any played with the front radar as parking sensor setting in the engineering mode? Does it even work?

Can anyone give a bit it of advice on the best fuse to piggyback off for these cables. I'm not too sure where or what B+ is. The yellow cable has an inline fuse.

I am looking to fit an after market birds eye camera set to my mg5. Any ideas or photos of the video input of the existing camera?