Search results

Hi. I don't remember that. I only had to connect the wire up to the boot latch switch. This told the car the tailgate button or keyfob had been pressed.

Sorry it's taken a few days to respond. If I remember correctly, the yellow wire on mine is the unlock wire and has to be connected to the wires for the tailgate latch. If you take the tailgate trim off, there's 2 wires that run to the boot release switch. Attach the yellow wire to one of these...

Hi. I managed to install it on my MG4. It was an almighty ball ache and took a couple of goes (test fitting and running wires, etc). The hardest bit is getting the wiring through the car into the tailgate through the rubber. Absolute nightmare. I've attached a copy of the instructions I had but...

Honestly, it's a nice feature to have and it's a bit of a show off thing a little bit. If I had to recommended it, probably not for the price and the hassle to install it.

I ran mine down the side of the headliner and door seals. Found a earth in the tailgate to save running another wire.

Any fuse on the 12v permanent as shown in the photo. Just plug it in and test or get a multi meter on them but I think they are all permanent live on that row.

I'm in the same boat. Quite like the cream covers and might be tempted to give them a go.

They fixed it with some software updates and now it pre heats without having to pre heat the battery. Going back in again on Tuesday for the heating to be looked at again.

I completed the powered tailgate install at the weekend. It’s great and a feature I’ve always wanted with carrying kit about and having my arms full when trying to open the tailgate. However, it was an absolute mission to install and run all the cabling and wouldn’t recommend unless you know...

My accelerator cover slipped off. Only noticed when I was struggling to accelerate, looked down and it had half slipped off and was jamming into the carpet. Left it off for now.

The other option is drilling a hole in the plastic which others have done. Only reason I haven’t is if MG eventually recalibrate the sensor and I would need to get a replacement cover. Although, it’s unlikely MG will 😂

I thought I would post to see if there’s an improvement or not and how long it takes to deform like my PLA ones.

With the bright sunlight (finally) in the mornings, my auto lights gone on and off all the time when passing shadows caused my trees, etc. Decided to print off and try the 3d printed ASA covers and see if they deform or not.

Might get some business if you could disable LKA via the ODB like on VAG and BMW vehicles.

👍🏻 I took mine in last week for them to fix it and it still doesn’t work. Meant to have phoned me back after raising a case with MG UK but haven’t heard anything. I’ll have to chase them today.

Did they resolve you digital key issue?

Will do.

Me too!

I had my Trophy a month ago and the HVAC is about 5 degrees out. I had to set mine to 26 degrees this morning to get any heat and even that was weak. I would say the equivalent to 21 degrees in my old Mini. I dropped the car off on Friday for the dealer to look at it but they couldn't fix it...

Just come back from MG Redditch. Exactly the same as before. They've updated some of the modules in the car but still on R33 for the infotainment system. HVAC system also still out of calibration. MG Redditch have opened a case up for both the digital key and HVAC system with MG UK. They will...