-
-
From what has been revealed in these posts it would appear to be an assembly issue which could be present on any vehicle. Surely this... -
BugEyed replied to the thread MG5 Brake failure.Do they do anything more than wash the car? :confused: Seriously though, this should not have left the factory in that state. What...
-
As far as I can tell one hose on one wheel has been damaged so that should result in 50% of the cars braking ability being lost the...
-
BugEyed replied to the thread MG5 Brake failure.There's two separate issues here: You can reject a car very easily in the first month, and this defect would allow it. After one month...
-
BugEyed replied to the thread MG ZS electric drivers seat to fit an MG5?.Always good advice, it'll throw an airbag error at very least.
-
BugEyed replied to the thread MG5 Tow bar again.That's fairly standard.
-
BugEyed replied to the thread MG5 Brake failure.plus the "handbrake" (emergency for any US readers) brake, unless they are counting that as the second system.
-
I think the previous example was an isolated incidence of bad assembly but we never did bottom out the question of why that would cause...
-
for facelift https://forums.automobile-propre.com/topic/attelage-45648/?do=findComment&comment=1212358...
-
I did it myself so the cost was negligible, I had some good quality synthetic oil on my garage shelf looking for a purpose. Just about...
-
BugEyed replied to the thread MG5 State of reduction drive oil….There's two different failure modes for the lubricant, either age/mileage or debris from manufacturing. The former may be as high as...
-
James in this video does some and in the comments below when asked he reckoned about 60,000 miles is about the right time.
-
BugEyed replied to the thread MG5 State of reduction drive oil….It's a big issue with Nissan LEAF where likewise it's not a service item. Obviously different design/manufacturing processes etc, but it...
-
BugEyed replied to the thread MG5 Charging issues with Ohme.Have you checked the state of the Control Pilot pins in the Ohme plug and the MG's socket? A clean with contact cleaner could help as...
-
BugEyed replied to the thread MG to lose customers for good?.Sorry to see you (and your sense of humour) go. I think that you have made the correct decision. But sadly I don't think that MGUK or...
-
-
Loading…
-
Loading…
-
Loading…
