Recent content by paul256

Thanks, yeah I've spent more time than is healthy reading up and this and think I've covered it all! Did you ever take the input current on the Multiplus above 10A? My Quattro is the 10000 version and it seems that it will only accept a minimum input current of 10.5A. Also did you put another...

Thanks for your responses, it's much appreciated. I originally had the grid connected to AC-IN1 as that's the priorty input on the Quattro. I've only recently got the mg4 and tried hooking that up AC-IN2 but didn't work and everything I've read suggests putting the generator connection on...

When the MK3-USB is connected ESS is non-functional but I'm not even getting pass-through. The Quattro detects 222V at 50.1Hz when the mg is in discharge mode but disconnects shortly thereafter and reverts back to AC-in 2 (grid). I am getting an out of phase error from the VE.Bus monitor when...

Thanks for replying. I've reduced down the input current over several steps from 16 down to 4 and used lots of variations of the tick boxes that are meant to help when using a generator such as Dynamic current limiter, turning off the UPS function and using weak AC input when charging but with...

Sorry to revive an old thread but I'm looking to do the same using a Victron Quattro. I've connected the MG to AC-in-1 which is the recommended input for using a generator but I cannot get it to start transferring power. Did you change any of the settings within the Victron inverter such as LoM...