Search results

Thanks N2STY, is that on the leads from the LEDs or from the navigation light? Presumably we connect positive to positive and negative to negative? Hi Scoobeesnac, It looks like you've attached this to the passenger side light - is that correct or am I just misinterpreting the picture (I've...

Been looking to do this for ages and finally taken the plunge. Can I ask a few questions for those of you who paid more attention in physics lessons than I did please? Should I be disconnecting the 12v battery before starting this work? Presumably there's two sets of wire that I could clamp on...

When putting holes onto the bodywork should I be using some sort of rust inhibitor afterwards?

Anyone know if the gen1 mudflaps fit the gen2? I filched the mudflaps off our gen1 before it went off to Cazoo but haven't had a chance to look properly yet...

It really should be in the section swept by the windscreen wiper so most people put it in the middle at the top.

Sadly, I got all the parts together and then wimped out and sent them back as I was worried that it would invalidate the warranty (which I suspect we may need to lean heavily on down the line as the car gets older). Instead we bought a couple of these to hang off the interior handle: Nite Ize...

It looks pretty neat - have you seen any night time footage yet? What's the quality like?

It's a two parter but the 2nd part should be linked or come up in the side bar for recommended videos...

I've seen a lot of people on YouTube raving about the Viofo A129 range. Front and rear cams in either 1080p, 2k or 4k and usually quite a bit cheaper than the nexbase equivalents. There's a guy on YouTube (he may also be on this forum) who's done an installation video for a ZS EV too...

Do you think there'd be any problem with the heat given off the 5050 types? They'll be pretty close to the roof lining...

Thanks very much

Thanks - I'll give it a go! Do you remember the lights that you got? They look great!

Severnless, would you mind putting a picture of how you wired it in to the dome light please (or even a description)? It looks great but I'm a bit unsure about how complex it is to wire it up properly...