Blistering Issue IM6 Lights

[tmullen55]

I have only had my IM6 for 4 months and have noticed small blisters around the bottom of the light moulding, especially the tail lights. It is especially bad on the right-hand side tail light. I took it in for warranty and got told that MG had released a service bulletin saying that these blisters were 'normal' and part of the moulding process at the factory, and are not covered by warranty. This, in my opinion, is extremely poor for such an expensive MG vehicle. If this is a manufacturing issue, then in my opinion, this is the definition of a warranted repair. I will attach photos when I can. I just wanted to raise this issue with other IM6 owners who may run into the same problem. If I knew this was the level of support and quality of the vehicle, I would not have purchased it.

 

[MG Clive]

Welcome to MGEVs @tmullen55, I'd agree that it should be warranty, the pictures will be appreciated when you get chance to add them.

 

[LenEV2016]

Another famous MG characteristic, such a poor attitude

 

[NikLiverpool]

I wonder if this is due to heat and moisture?
In any case this should be replaced under warranty. No excuse.

 

[salty]

Definition of Characteristic "Noun"
MGs answer for everything.

 

[LenEV2016]

It's really poor and was always going to be the risk with some dealers. Same budget service with a more premium car.
People will be less willing to accept their crap excuses when they are shelling out more cash on what is supposed to be a premium model.

Even worse if the service bulletin mentioned actually exists