Search results

For those MG ZS EV dog 🐩 owners who might be interested, I purchased this £21.99 back seat dog hammock from Amazon on a chance it would fit the ZS. I’ve just fitted it this morning and I have to say it fits a lot better than I expected and it’s well made (for the money) so our nervous 😬 car...

Yes the car stops charging on unlock

For anyone who likes to have additional data on their MG ZS EV (mki or mkii) then if you have an OBD2 dongle ELM327 like the NEXPEAK NX101 PRO or similar like I do then you can get State on Health and battery temperature etc.. The Thai app works on android phones only and is available free of...

The ac/dc charging converter gets very warm when charging on 7kw home charger in uk so I assume the foam will insulate the converter and potentially not allow components to breath / cool as they should.

Not sure I took the car to the hardware store and 8mm bolts and threads were what he said fitted

Unfortunately not on the new phone front as it's a work phone so I am keeping the out of date Iphone to avoid having to move to Samsung the only alternative.

No. Unfortunately the HV 400v battery needs to be engaged for V2L to work and effectively that means the car is in ready mode which also means you cannot lock the car whilst in ready mode so the drl's remain on. There is a Thai android only app that you can use (works on mki but not tried it on...

I just wish I had a newer Iphone that offered wireless charging so I could use this in my Trophy Connect but as its an old IOS Iphone6 ill make do with the 12v socket connector that converts to usb socket with a wire to the phone (old school):)

The torx screws on my type two plug socket are 6 - point

Does this help

I’ve no idea.

Now that's just too obvious lol. I tend to make things more difficult:-) Good tip @N2STY

8mm bolts used and some sellotape and Stanley knife as the box has a tendency to crack when you cut into it so the sellotape is to reinforce the brittle plastic.

8mm bolts @IanE

A £4 frunk with a lid :cool: No moaners please about safety as it houses my V2L cable (that I made for £50) and nothing else. It's also non-permanent and only used when needed.

Not taken seriously Rob! :cool:

I made the V2L cable after buying a 16amp type 2 cable for £40 and then buying a £10 waterproof outdoor 13amp socket and connected this to the redundant end and then installed a 470 ohm resistor within the charge socket end and Bobs your Uncle you have a homemade V2L cable for £50 as opposed to...

The official rating for the MG ZS EV facelift V2L is 2.2kW which is exactly the same as my tumble dryer but don't forget the dryer wont pull 2.2kW the whole time in its drying cycle. Boiling the kitchen kettle works well too and I have tested items above 2.2kW up to 3kW but I wouldn't recommend...

Flat top I bought a 2nd hand 16amp type 2 cable £40 then bought a £10 waterproof 13amp socket and attached that to the end after removing the redundant connector then I installed a 470 ohm resistor that the MG recognises as V2L for £50 all in. You can buy them for £130 but doesn’t take long to...