I assume you mean the charging point flap in the front grille. When you slide it down, you have to then press it in using your hand on the MG badge for it to lock in place. It then sits flush with the rest of the grille.Is it normally that the loading flap doesn't close completely?
It seems to be a little open, when the flap is fold down.
Thanks for helping posts
Make sure the rubber bungs are pushed fully inIs it normally that the loading flap doesn't close completely?
It seems to be a little open, when the flap is fold down.
Thanks for helping posts
If you mean the tailgate there are a couple of adjustable rubber bungs that you can screw in or out to improve fit. This may help. I don‘t know of any tailgate issues on the ZS though.Is it normally that the loading flap doesn't close completely?
It seems to be a little open, when the flap is fold down.
Thanks for helping posts
I have to admit to doing this! (twice so far, with bungs akimbo flapping around too!) You actually can't easily see it in the up position whilst driving.I passed another mg zs going other way last week ,must have being doing at least 50 . National speed limit road.His front charging port fully opened up.It was either broken or he was blind.I don't think you could not see it !.
At least it looks like the flap has strong hinges ?
The boot cover on the ZS is a solid piece, AKA parcel shelf.He could also meet the pull boot cover there is a small gap between the back seat and the holder for the slide cover.
It does not on our MG , it still pops out about 10mm away from the rest of the grill ! I feel it should lock into place ?? Any suggestions please ?I assume you mean the charging point flap in the front grille. When you slide it down, you have to then press it in using your hand on the MG badge for it to lock in place. It then sits flush with the rest of the grille.
A bit of silicone grease spray on the latch.It does not on our MG , it still pops out about 10mm away from the rest of the grill ! I feel it should lock into place ?? Any suggestions please ?
Check both bungs are pushed fully in and in the correct order.It does not on our MG , it still pops out about 10mm away from the rest of the grill ! I feel it should lock into place ?? Any suggestions please ?