Mobile phone falling onto floor

My mobile kept falling off the ledge above the usb ports when I went around corners. The simplest and cheapest upgrade to fix this is a piece of elastic tape, thread through the holes for cables at either end of the ledge, and tied underneath to make a loop. The phone is put under the elastic band and connected to CarPlay by a cable.

 

[Diggsy]

I found it depends a lot on what you use to clean the mat. Some products leave it very slippery.

 

[chromeskull]

I bought this mat from Amazon far better grip, holds my phone around sharp corners.
Jimisha Anti Slip Mat

It does require cutting down on one side to make it fit better. Just use the original mat as a template to cut it down.

 

[mhoolahan]

i got some grey self adhesive foam from hardware store. about 8mm thick i suppose. cut a shape to allow the phone to sit cradled in. doesn't go anywhere now.

 

[jamakr4]

MG4 electric Phone Railing by Memphis8403MakerWorld: Download Free 3D Models

If you're going fast in the MG4, your phone can fly out of the induction shell, this tool will keep it in place!

makerworld.com

If you know somebody with a 3d printer this should fix it. As an alternative: Just hire a 3d Printing Service or look for a shop that just sells the printed part.

eg: Amazon.de

 

[MG Clive]

This was my solution.

Forum thread HERE.

 

[Kevin Smith]

I found it depends a lot on what you use to clean the mat. Some products leave it very slippery.

Clean the mat? Not done that in 25 months!

 

[salty]

Clean the mat? Not done that in 25 months!

Ya phone should stick to it then.

 

[Steve Kaye]

I simply don't put my phone there, so its not an issue.