jpk
Established Member
How high can you inflate the tyres above the recommended 2.6 bar without triggering an alarm? Or can you set a higher pressure, say 2.8 bar, and zero it out so the car now treats that as its nominal value?
I expect it can be changed with the right ODB2 tool, but there's certainly no user-friendly way.Thanks all. I'm a little surprised the system can't be reinitialised when changing the pressures but it's good to know I won't be getting bonged when I raise it to 2.8 bar ?
I have an SE and noticed the range (and more specifically the miles/KWh) drop as soon as it got cold. The tyre pressures also dropped, they'd been 2.6 before in the autumn, and they dropped to 2.4 when it was cold at about 5C.
After reinflating to about 2.65 bar when cold, the miles/KWh went back up almost to summer range.
I wonder how much of the reduced winter range is due to tyre pressures dropping in the cold, rather than the battery being cold? The rest of it can be explained by the heater, that uses far more power than the a/c does in the summer.
That's lorry tyre pressure.I once received a new Nissan Qashqai with the front right tyre misinflated to 5 bar. It drove fine including at motorway speeds before I checked it and corrected it.
Never had problem afterwards with the tyre and it lasted a good 25,000 miles.
The amount of air coming out when you disconnect won't affect the pressure - it takes quite a while to reduce the pressure by 0.1bar.I inflated mine to about 2.7 (on the gauge to allow for leakage taking the connector off) on one of the coldest days to get rid of the low pressure warnings. Straight away I was up to 2.8 the next day. It's been running fine at that. Anecdotal but range does seem much better. It went up as high as 3.1 on one of the warmer days so I brought it down to 2.8 ish. Now I'm between 2.6-3.0 depending on the weather. No issues so far and I'm getting over 350km if I drive carefully in urban areas with minimal heating in the SR.