MG4 Frunk now available

Have ordered a set with the struts. The struts were a definite buy, even if I decided against the frunk as an option. I'm thinking that the struts that are being provided may be better than the AliExpress ones.
They have been sent and are somewhere on the Nullarbor now.
 
Around 1kg of plastic for a 3d printer is around £20, but most commonly avaliable 3d printers are quite limited in the size of objects they can print - Anything larger than 300mm in any dimension it considered tricky, but not impossible
Could it be made in 2 pieces and held together with a couple of small nuts and bolts.Never seen a 3D printer in action I would like to see one working.
 
Has anybody mentioned and i know it is silly but this invalidates the warranty if fitted?
Reasons, mod of vehicle in critical component area effecting airflow and close proximity to critical wiring that could cause issues.
 
Not sure about the warranty, my frunk installs using the same clips and holes that are being used by the plastic cover that's there from factory. I'm sure they'll use it to get out of a warranty claim if they can.
 
My dealer would not service my ZS until I removed my home made frunk said it interfered with the air flow
 
Mine arrived from EVCars, remove the cover, fit the ball head bolts and it slides over them. Easy to remove and makes it frunkier. Or frootier. The struts were a little bit more involved, mostly removing the clips on the bonnet liner, but now done. Info from MG Australia suggested no warranty concern as such.
 
Support us by becoming a Premium Member

Latest MG EVs video

First Look: MG IM5 & IM6 – Premium EV Saloon & SUV Unveiled at Goodwood!
Subscribe to our YouTube channel
Back
Top Bottom