MG4 Software Update Thread

[BingBong]

@BingBong You could solve your WiFi problem either with a long ethernet cable (cheap, CAT5 is enough for around 100 Mbit/s) or you can use your phone's hotspot function . USB Tethering is an option, too --> you use your phone like a wired modem.

For the missing message: Maybe a soft reboot is needed? Long press on home button.

The problem is that there is even not 4g/5g signal there.

About the message. I tried. Also tried factory reset.

When i connect to the charger there is the estimate time message there

 

[Mouss]

I am from Israel. Also Romanian citizen...
My problem is that i don't have WIFI at my garage. If i had i would order vnci.

Btw, anyone noticed that R67 doesn't have "please plug to charger" message?View attachment 43191

It's the normal screen since R67 for SWI68.
Same with R40 for SWI69.
The message was disturbing: when you drive, it say "please plug to charge..."
Fun fact: it came back with R45 for SWI69

 

[BingBong]

It's the normal screen since R67 for SWI68.
Same with R40 for SWI69.
The message was disturbing: when you drive, it say "please plug to charge..."
Fun fact: it came back with R45 for SWI69

Good to know.
And yes i agree that this message is pointless. "Please plug to charge" even on 100% SOC

 

[EV Focus RO]

I agree. I just updated to R67 with 68.4.9.0. Charge limit scroll still functional.

White android auto theme at startup did not solved at R67. Interesting if at R71

White android auto theme at startup is not fixed in R71

 

[JDPlays]

So i know from a lot of reading around these forms that the software in Australia is a little bit different then the rest of the world, but I have no idea what my
SWI131-29958-1100R05 compares to when comparing to the R27-67-71 ETC as the Australia version has the SWI131 code.

Also my MCU version is -125.1.3.0 which i believe is a real impossibility as ive never seen a negative version number!

Attached is the software page from the car

 

[serkancelenk]

Hello,

In the Sips application, there is a question mark on the EPS module calibration—is this normal?

My other question is: What is the ESCL module, and why does it appear as “…” (or blank/incomplete) in the calibration file?

Is there a problem with these modules?



“In Turkey, since the T-Box units have been replaced, the T-Box version appears different as you can see — and accordingly, it’s already showing as not matching the vehicle’s VIN number.”

 

[EV Focus RO]

So i know from a lot of reading around these forms that the software in Australia is a little bit different then the rest of the world, but I have no idea what my
SWI131-29958-1100R05 compares to when comparing to the R27-67-71 ETC as the Australia version has the SWI131 code.

Also my MCU version is -125.1.3.0 which i believe is a real impossibility as ive never seen a negative version number!

Attached is the software page from the car

Latest for SWI131 looks to be R27
HERE

 

[DonBattino452]

@serkancelenk Please have a look on my post here. When you're in the ECU section of SIPS, it shows all control units in one list and you can check or . One Press sometimes shows a list with or. If you need further assistance feel free to ask.

And about your TBox: If it's a replacement, you have to flash it like a replacement because it needs your vehicle's VIN written in.