I just went out for a look to see how difficult fitting the new number plate will be and have fallen at the first hurdle because I am being cautious...
I can only see two screws in the old plate so I'll need to drill two holes in the new one, and presumably use double sided tape lower down on the plate (otherwise I imagine it would vibrate).
Are those screws self-tapping screws, or do I have to remove the trim on the inside of the boot lid to access the other side?
Either way, would they be re-usable?
I didn't want to go ahead and just remove them to see just in case something dropped off the back of them which I then couldn't retrieve easily!
EDIT: and wouldn't sticky pads be easier?
2nd edit: And presumably I can just take off the black bar and not do anything with the screw holes, or do I need to out some bungs in?