Diagnostic VDI, VNCI, MDI with MG4

[Deepbluexl]

@marekraska But thats Not an MG4... So not related to the topic..

 

[haloweenhamster]

After unpacking, I obtained:

• 11248183_02.sw (date 2021.09.27)
• AS23PEU_ClientTdbGdb.sw (date 2025.02.28)

I uploaded both to a USB flash drive and nothing happened.

I downloaded three “AS23PEU_ClientTdbGdb.sw” files and chose the most recent one.

Does the flash drive need to be specially prepared? Formatted FAT32.
View attachment 39726View attachment 39725

Unfortunately I have no experience with that model (only MG4)
With the MG4 some updates like TBOX you had to place the files in a folder with the correct name for the car to see it
It's even different for the SE & Trophy for the FICM
The software loading instructions might help if you have the document

 

[marekraska]

The manual does not contain such information.
I'll keep looking. Thank you for your help.

 

[rt45433]

I have now got my VDI3 hardware and went to get everything setup. I first installed everything on my surface pro and when opening VNCI Device Manager is would show the device and its correct serial number but it would just show the firmware as 0.0.0.0 which was odd. I then decided to install all the software and drivers onto my gaming pc and when opening VNCI Device Manager it showed the hardware with the correct SN and the firmware version now as 1.0.0.9 so i then put everything in the car and when I connect the VDI3 to the cars OBD port it will then not show up in either VNCI Device manager or VCI Manager. When i remove the VDI3 from the cars OBD port it then shows up both on VCI Manager and VNCI Device Manager. Am I doing something wrong? Any help would be super helpful. This is the hardware I bought.

VNCI VDI3 für Rongwei MG Wuling Baojun Datong Diagnoseschnittstelle unterstützt DoIP- und CANFD-Protokoll, passend für SAIC-Gruppensoftware - AliExpress 34

 

[hojnikb]

I have now got my VDI3 hardware and went to get everything setup. I first installed everything on my surface pro and when opening VNCI Device Manager is would show the device and its correct serial number but it would just show the firmware as 0.0.0.0 which was odd. I then decided to install all the software and drivers onto my gaming pc and when opening VNCI Device Manager it showed the hardware with the correct SN and the firmware version now as 1.0.0.9 so i then put everything in the car and when I connect the VDI3 to the cars OBD port it will then not show up in either VNCI Device manager or VCI Manager. When i remove the VDI3 from the cars OBD port it then shows up both on VCI Manager and VNCI Device Manager. Am I doing something wrong? Any help would be super helpful. This is the hardware I bought.

VNCI VDI3 für Rongwei MG Wuling Baojun Datong Diagnoseschnittstelle unterstützt DoIP- und CANFD-Protokoll, passend für SAIC-Gruppensoftware - AliExpress 34

did you try to run it in VDS or SIPS ?